Bay Window Danbury
Elevating Roof

 

 

homeContactShippingView basketCheckout

The Danbury models of camper were all fitted with a pop top type of roof, most had a red and white striped flat sided bellows, inside were tags to locate a flat elastic that runs all around the bellows.

There were a couple of models but all have triangular spring loaded side supports to aid in lifting the roof, to hold the roof up there are four rods that hinge down from the fibreglass roof and locate on top of the van roof either in holes or in a clevis on earlier models.

The bellows is attached at the bottom by flat strips of aluminium riveted to the van roof and at the top by tacks into the fibreglass pop top, these are then covered by a vinyl finishing strip.

 

Experience in our workshop has shown that the Danbury roof tends to vary in size hence to supply a bellows for DIY fitting we need our customers to supply some simple measurements, we will then make a bellows to fit, these can be supplied in any of our plain/striped plastic materials.

 

Elevating roof bellows in plain or striped plastic
£275
    Click here for colour guide
     
Elevating roof seal for edge of glassfibre
£25
Internal finishing strip in cream vinyl £39.00
     
   

 

 

Copyright © Poptop Parts 2004 - 2017